Photo 1

O-ring 99,1x5,7 PU C0

Code2EOR0005
In stock124pcs
Priceexcl. VATFrom €4.48/pcs
O-ring 99,1x5,7 PU C0—
€4.48excl. VAT

Price by quantityexcl. VAT

Available for registered usersSign in or create an account

Technical data

Properties
Seal typeO-ring
Material typePU
BrandArtic seals
Weight14g
O-ring dimension
Inside diameter99,1mm
Cross section5,7mm

Description

O-ring 99,1x5,7 PU C0 is an O-ring: a sealing ring with a circular cross-section. Inner diameter: 99,1 mm, cross-section: 5,7 mm, outer diameter: 110,5 mm. Material: PU. An O-ring is a single elastomer ring. It is compressed in the groove during assembly, and the pressure of the medium then deforms it further, increasing the contact force on the sealing surfaces, so no additional clamping parts are needed. It is used for static and dynamic joints in hydraulic and pneumatic systems.

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all