Photo 1

Rod seal RSB 88,9x101,6x9,53 C0

CodeRSBI 3500 4000 0375 C0
In stock54pcs
Priceexcl. VATFrom €3.40/pcs
Rod seal RSB 88,9x101,6x9,53 C0—
€3.40excl. VAT

Price by quantityexcl. VAT

Available for registered usersSign in or create an account

Technical data

Properties
Seal typeRSB
Material typePU
Material codeC0
Foreign code2ERSBI25
BrandArtic seals
Weight18g
Hydraulic seals dimension
Rod diameter d88,9mm
Groove Diameter D101,6mm
Seal width h9,53mm

Documents

Description

RSB 88,9x101,6x9,53 C0 [2ERSBI25] is an RSB-type rod seal made of C0 polyurethane based on polyester-caprolactone. It is intended for use in hydraulic systems. The design of this double-lip seal is effective in demanding conditions, with the main lip sealing the medium and the second lip providing additional protection against contamination. The seal design prevents the stick-slip effect and compensates for material shrinkage at low temperatures. Inner diameter (d): 88,9 mm Outer diameter (D): 101,6 mm Height / thickness (H): 9,53 mm Dimensions in inches: 3,5” x 4” x 3/8” The seal has the following technical parameters: Working pressure: up to 400 bar Linear speed: up to 0,5 m/s Hardness: 93 Shore A ±2 Material: C0 polyurethane with high abrasion resistance and low compression set

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all