Photo 1

Rod seal RSD 6x10x4,5 PU

CodeRSD 0060 0100 045 C0
AvailabilityOn request
Rod seal RSD 6x10x4,5 PU—

Technical data

Properties
Seal typeRSD
Material typePU
Material codeC0
Foreign code2ERSD003
BrandArtic seals
Weight1g
Hydraulic seals dimension
Rod diameter d6mm
Groove Diameter D10mm
Seal width h4,5mm

Documents

Description

The RSD-type gland seal from the renowned Italian manufacturer Artic Seals is a double-lip ring made of polyurethane C0 (polyester-caprolactam based). It is a product intended for use in hydraulic cylinders. Thanks to the elasticity of the material, both lips are pressed against the mating surface. The additional lip stabilises the seal and protects it against external contamination. The design prevents the stick-slip effect and supports the sealing action at low temperatures. Technical data: Working pressure: up to 400 bar Linear speed: up to 0,5 m/s Hardness: 93 Shore A ±2 Material: polyurethane C0 with high abrasion resistance and low compression set The product with dimensions 6x10x4,5 PU, marked with the symbol [2ERSD003], is an excellent solution for everyone looking for a reliable and durable gland seal.

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all