Photo 1

Static seal SSA 72,6x68x3,8

CodeSSA 0726 0680 038 C0
AvailabilityOn request
Static seal SSA 72,6x68x3,8—

Technical data

Properties
Seal typeSSA
Material typePU
Material codeC0
Foreign code2ESSA266
BrandArtic seals
Weight2g
Hydraulic seals dimension
Groove Diameter D72,6mm
Groove width H3,8mm
Groove Diameter d68mm

Documents

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all