Photo 1

Rod seal K22 36x46x10

CodeK22-036/2 PU
In stock19pcs
Priceexcl. VATFrom PLN 12.96/pcs
Rod seal K22 36x46x10—
PLN 12.96excl. VAT

Price by quantityexcl. VAT

Available for registered usersSign in or create an account

Technical data

Properties
Seal typeK22
Material typePU
BrandKastas
Weight11g
Hydraulic seals dimension
Rod diameter d36mm
Groove Diameter D46mm
Seal width h10mm

Documents

Description

Hydraulic gland seal type K22 - single-acting seal. Also called a "lip seal". It has lips that differ in shape and size. The inner (dynamic) lip is shorter than the outer (static) one and faces the piston rod, which gives a high sealing effect. The K22 ring is used to seal the piston rod of a hydraulic cylinder. It is made of PU material. The dimensions d and D given in the designation correspond to the housing; that is, to select a seal, you need to measure the inner and outer diameter of the housing in which the ring is installed. The third dimension b in the designation is equal to the height of the ring. This value b should always be smaller than the groove width B. This clearance is necessary for the seal to work properly. The difference B-b for cups with a height of up to 4,76 mm is 0,5 mm (-0 / + 0,2), for cups with a height above 4,81 mm it is 1 mm (-0 / + 0,2). This ring can be easily installed in closed grooves. Use installation tools made of soft materials without sharp edges. Lubricate the seal with hydraulic oil before installation.

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all