Photo 1

Rod seal RSD 126x134x8 PU

CodeRSD 1260 1340 080 C0
In stock20pcs
Priceexcl. VATFrom PLN 22.20/pcs
Rod seal RSD 126x134x8 PU—
PLN 22.20excl. VAT

Price by quantityexcl. VAT

Available for registered usersSign in or create an account

Technical data

Properties
Seal typeRSD
Material typePU
Material codeC0
Foreign code2ERSD739
BrandArtic seals
Weight14g
Hydraulic seals dimension
Rod diameter d126mm
Groove Diameter D134mm
Seal width h8mm

Documents

Description

Rod seal RSD 126x134x8 PU is a product from the renowned Italian manufacturer Artic Seals. This is a double-lip ring made of polyurethane C0, intended for use in hydraulic cylinders. Seal size: Inner diameter: 126 mm Outer diameter: 134 mm Ring height: 8 mm Manufacturer code: 2ERSD739 Material: Polyurethane (PU) The RSD-type gland seal features both lips pressed against the mating surface thanks to the elasticity of the material. The additional lip stabilises the seal and protects it against external contamination. The design prevents the stick-slip effect and supports sealing performance at low temperatures. Technical data: Working pressure: up to 400 bar Linear speed: up to 0,5 m/s Hardness: 93 Shore A ±2 Material: polyurethane C0 with high abrasion resistance and low compression set

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all