Photo 1

Rod seal RSD 135x150x11,5 PU

CodeRSD 1350 1500 115 C0
AvailabilityOn request
Rod seal RSD 135x150x11,5 PU—

Technical data

Properties
Seal typeRSD
Material typePU
Material codeC0
Foreign code2ERSD752
BrandArtic seals
Weight61g
Hydraulic seals dimension
Rod diameter d135mm
Groove Diameter D150mm
Seal width h11,5mm

Documents

Description

Rod seal RSD 135x150x11,5 PU is a product from the renowned Italian manufacturer Artic Seals. This is a double-lip ring made of polyurethane C0, intended for use in hydraulic cylinders. Seal size: Inner diameter: 135 mm Outer diameter: 150 mm Ring height: 11,5 mm Manufacturer code: 2ERSD752 Material: Polyurethane (PU) Technical data: Working pressure: up to 400 bar Linear speed: up to 0,5 m/s Hardness: 93 Shore A ±2 Material: polyurethane C0 with high abrasion resistance and low compression set Rod seal RSD 135x150x11,5 PU is an excellent solution for those looking for a reliable and durable seal for their hydraulic cylinders.

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all