Photo 1

Rod seal RSD 24x32x5,8 PU

CodeRSD 0240 0320 058 C0
AvailabilityOn request
Rod seal RSD 24x32x5,8 PU—
PLN 8.89excl. VAT

Technical data

Properties
Seal typeRSD
Material typePU
Material codeC0
Foreign code2ERSD133
BrandArtic seals
Weight2g
Hydraulic seals dimension
Rod diameter d24mm
Groove Diameter D32mm
Seal width h5,8mm

Documents

Description

Rod seal RSD 24x32x5,8 PU [2ERSD133] is a double-lip sealing ring made of polyurethane C0 by the renowned Italian manufacturer Artic Seals. It is designed for use in hydraulic cylinders, where both lips are pressed against the mating surface thanks to the elasticity of the material. The additional lip stabilises the seal and protects it against external contamination. The design of the ring prevents the stick-slip effect and supports sealing performance at low temperatures. The technical data of rod sealnia U RSD 24x32x5,8 PU [2ERSD133] are: Working pressure: up to 400 bar Linear speed: up to 0,5 m/s Hardness: 93 Shore A ±2 Material: polyurethane C0 with high abrasion resistance and low compression set Rod seal RSD 24x32x5,8 PU [2ERSD133] is a high-specification product that will meet the expectations of even the most demanding customers.

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all