Photo 1

Rod seal RSD 60x70x10

CodeRSD 0600 0700 100 C0
In stock83pcs
Priceexcl. VATFrom €2.75/pcs
Rod seal RSD 60x70x10—
€2.75excl. VAT

Price by quantityexcl. VAT

Available for registered usersSign in or create an account

Technical data

Properties
Seal typeRSD
Material typePU
Material codeC0
Foreign code2ERSD481
BrandArtic seals
Weight16g
Hydraulic seals dimension
Rod diameter d60mm
Groove Diameter D70mm
Seal width h10mm

Documents

Description

The RSD 60x70x10 U-ring is a product with number 2ERSD481, available in our online shop. This is an RSD-type gland seal from the renowned Italian manufacturer Artic Seals. It is made of polyurethane C0, which means it is polyester-caprolactam based. This ring is intended for use in hydraulic cylinders. Its design includes two lips that are pressed against the mating surface thanks to the elasticity of the material. The additional lip stabilises the seal and protects it against external contamination. The design of the ring prevents the stick-slip effect and supports the sealing action at low temperatures. The technical data of the RSD 60x70x10 U-ring (2ERSD481) are as follows: Working pressure: up to 400 bar Linear speed: up to 0,5 m/s Hardness: 93 Shore A ±2 Material: polyurethane C0 with high abrasion resistance and low compression set We invite you to buy the RSD 60x70x10 U-ring (2ERSD481) in our online shop.

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all