Photo 1

Rod seal RSD 90x102x10

CodeRSD 0900 1020 100 C0
AvailabilityOn request
Rod seal RSD 90x102x10—

Technical data

Properties
Seal typeRSD
Material typePU
Material codeC0
Foreign code2ERSD651
BrandArtic seals
Weight29g
Hydraulic seals dimension
Rod diameter d90mm
Groove Diameter D102mm
Seal width h10mm

Documents

Description

The RSD 90x102x10 U-ring is a product offered by the Italian manufacturer Artic Seals. This is a double-lip ring made of polyurethane C0, intended for use in hydraulic cylinders. Seal size: Inner diameter: 90 mm Outer diameter: 102 mm Thickness: 10 mm Manufacturer code: 2ERSD651 Material: Polyurethane (PU) Technical data: Working pressure: up to 400 bar Linear speed: up to 0,5 m/s Hardness: 93 Shore A ±2 Material: polyurethane C0 with high abrasion resistance and low compression set The RSD 90x102x10 U-ring is a product that will meet the expectations of even the most demanding customers. We invite you to shop in our online shop.

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all