Photo 1

Rod seal RSD 95x112x11,5 PU

CodeRSD 0950 1120 115 C0
AvailabilityOn request
Rod seal RSD 95x112x11,5 PU—

Technical data

Properties
Seal typeRSD
Material typePU
Material codeC0
Foreign code2ERSD669
BrandArtic seals
Weight50g
Hydraulic seals dimension
Rod diameter d95mm
Groove Diameter D112mm
Seal width h11,5mm

Documents

Description

The RSD 95x112x11,5 PU U-ring is a product from the renowned Italian manufacturer Artic Seals. This is a double-lip ring made of polyurethane C0, which is ideal for use in hydraulic cylinders. Seal size: Inner diameter: 95 mm Outer diameter: 112 mm Thickness: 11,5 mm Manufacturer code: 2ERSD669 Material: Polyurethane (PU) The RSD-type gland seal is characterised by both lips being pressed against the mating surface thanks to the elasticity of the material. The additional lip stabilises the seal and protects it against external contamination. The design prevents the stick-slip effect and supports the sealing action at low temperatures. Technical data: Working pressure: up to 400 bar Linear speed: up to 0,5 m/s Hardness: 93 Shore A ±2 Material: polyurethane C0 with high abrasion resistance and low compression set

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all