Photo 1

Seal VRA 86x70,0x9

CodeVRA 0860 0700 090 B0
In stock15pcs
Priceexcl. VATFrom PLN 24.94/pcs
Seal VRA 86x70,0x9—
PLN 24.94excl. VAT

Price by quantityexcl. VAT

Available for registered usersSign in or create an account

Technical data

Properties
Seal typeVRA
Material typePU
BrandArtic seals
Rotary seal dimension
Shaft Diameter86mm
Housing diameter70mm
Groove width H9mm

Documents

Description

The VRA seal protects joints, bearings, bronze bushings, flanges and other mechanical parts that rotate or turn through a limited angle. Made of the B0 compound with low permanent deformation, it keeps water, mud and other contaminants out. The wide range of diameters makes it easier to choose the right size. Technical data Pressure: this is not a conventional pressure seal; the working pressure is whatever results from keeping the grease inside the system. Medium: mineral oil and grease, non-aggressive gas Material Standard polyurethane, 90 Shore A. Compound: B0. Assembly Lubricate the metal parts where the seal will sit with mineral grease. Remove burrs and sharp edges first: they reduce the sealing performance.

Material

PU / TPU / H-PU (polyurethane)

  • Standard PU / TPU-30 °C to +80 °C

Best for high pressure and abrasion, in mineral hydraulic oil. Standard PU must never meet hot water, steam or brake fluid, or run hotter than +90 °C.

Chemical resistance
Can be usedDo not use
Extreme pressure and pulsation (up to 40-50 MPa, very resistant to extrusion into the gap)Hot water and steam with standard PU: hydrolysis, it breaks down into powder
Abrasion, friction, cutting and tearing (4-5 times tougher than NBR)Glycol brake fluid (DOT 3, DOT 4, DOT 5.1): swells quickly
Mineral hydraulic oil (HL, HLP) and greaseHigh temperatures above +90 to +100 °C with standard TPU: it softens
Fuel oil, diesel and technical oils (aliphatic hydrocarbons)Strong (concentrated) acids and alkalis: sulfuric, nitric, caustic soda
Ozone, weather and sunlight (does not crack from weather)Acetone, MEK, toluene, benzene, dichloromethane (polar and aromatic solvents)
Water-based fire-resistant fluids HFA, HFB (only special H-PU)Synthetic ester oils and fire-resistant fluid HFD-R
Dry compressed air and technical gasesStrong alcohols (methanol, ethanol): swelling

Water and heat destroy standard PU: above +50 to +60 °C in water or damp oil it turns into a sticky paste or crumbles. If the system contains water or an emulsion, use only H-PU (hydrolysis-resistant).

We recommend: Industrial chemicals

View all

We recommend: Tools

View all