Photo 1

Wiper K10 180x192x8,2/11

CodeK10-180
AvailabilityOn request
Wiper K10 180x192x8,2/11—
€8.57excl. VAT

Technical data

Properties
Seal typeK10
Material typeNBR
Material codeNB9001
BrandKastas
Weight66g
Wipers dimension
Inside diameter d180mm
Outside diameter D192mm
Width h8,2mm
Width H11mm

Documents

Description

K10 wiper rings are installed in hydraulic cylinders to remove dirt, contaminant particles, moisture, etc. from the piston rod (tube), thereby protecting the hydraulic system against contamination. These wipers are selected by the following dimensions: inner diameter 180 mm, outer diameter 192 mm, seal height 8,2/11 mm. Made of NBR NB9001

Material

NBR (nitrile butadiene rubber)

  • Operating temperature-30 °C to +100 °C

Good with oils, fuels, water and compressed air. Not for brake fluid, solvents, strong acids or sunlight.

Chemical resistance
Can be usedDo not use
Mineral oil, grease and hydraulic oil (H, H-L, H-LP)Brake fluid (DOT 3, DOT 4, DOT 5.1): the ring swells quickly
Diesel, fuel oil, keroseneSunlight and open air (ozone): the rubber cracks
Petrol (gasoline), propane, butaneAcetone, MEK, ethyl acetate and similar solvents
Water and water-based liquids, up to +80 °CBenzene, toluene, trichloroethylene (aromatic and chlorinated solvents)
Compressed air, also with oil mistSynthetic ester oils and fire-resistant fluid HFD-R
Water-based fire-resistant hydraulic fluids (HFA, HFB, HFC)Strong (concentrated) acids, e.g. nitric and sulfuric, and strong oxidizers
Oil-and-water emulsionsSteam and hot water above +100 °C
Weak acids, alkalis and salt solutions, at room temperature
Use with cautionPetrol with a lot of bioethanol (E10, E85): better use FKM (Viton)

Shows low compression set within the recommended temperature range.

We recommend: Industrial chemicals

View all

We recommend: Tools

View all